There was a faint rust ring, which I then proceed to measure (.' If you want a job done right give it to a lazy man!).The result, measured with a carpenter's tape measure, was approximately 13/16. I sort of smooshed the inner edge around with my fingers and then peeled the tape off. Rather than try to crane my head down and look up inside there, I took a square of masking tape and covered the hole with it. Going from memory, the table says that MT-2 is about.70' and MT-3 is about.9375 (those are not exact!)Whatever the measurement for MT-3 was said to be I calculated that it was about 15/16'.A little while ago, I went in to where the drill is standing. Bill,Thanks a lot for your link to the different morse taper specifications.However, I'm somewhat confused. They're certainly much smaller machines than this one.Is there a way to measure this? I hate to squander $100 or more on a chuck and it be the wrong critter.ThanksV. So MT3 might be right? I have a couple of Chinese drill presses but don't remember what size they are. It was too small but it did not feel as if it was going to disappear. Delta Dp350 Drill Press Replacement Parts And Accessories I don't know its age but it could easily be 20 years old or even 40.I happened to have a MT2 live center from a lathe I bought at the same time as the drill so I tried it.
The machine is a 17-760 (17') Delta industrial drill press. The quill (if that's the name for it) has a tapered hole in it. Would somebody hazard a guess as to what the most common, and second most common drill press tapers are? I seem to remember its MT but don't remember the number.I would like to find a chuck for it.Thanks,V. Still, it weighs at least a few hundred pounds.Anyway, it came with no chuck.
So, I guess you'd say it's a 'medium size' machine. It was in an industrial setting and has a 460V / 230V 3 phase, 1 HP motor. 'Large' being a relative term, by that I mean 'way more robust than the cheap Chinese press it will replace. Guys,At a recent machine auction I bought a pretty large, industrial duty Delta drill press.
0 kommentar(er)
